Every screw was in it's place. I've tried adaptors, three sets of headphones and am a little frustrated that even managing to replace the jack hasn't solved this. If you have signal problems after removing the logic board, check this ground tab. They should be labeled with orange stickers numbered 1 and 2. his comment is here
Introduction Has your ear speaker stopped working? Quote from Vishal Vaidya: Is there a way of replacing the connector? This will keep glass shards contained and provide structural integrity when prying and lifting the display. Check the other two cables as well.
Cargando... Iniciar sesión Transcripción Estadísticas 30.699 visualizaciones 77 ¿Te gusta este vídeo? John Zemko - 07/29/2010 Reply As mentioned, some 3g phones there is a small metal clip holding down the camera (held in place by the screw there). Next take the pointed end of your spudger (or you can use another plastic pointed object if you don't have a spudger) and pry up the 2 clips at the top
Vishal Vaidya - 03/30/2010 Reply I HAVE DONE IT GUYS SO THANK YOU. Jul 27, 2012 8:19 PM Helpful (0) Reply options Link to this post by EpauEpedra, EpauEpedra Aug 15, 2012 7:07 PM in response to earthgirl2 Level 1 (0 points) Aug 15, Switch the green mute switch down (towards the back side of the iPhone) into mute position. Iphone 3g Speaker Not Working Cor Berkelaar - 03/27/2010 Reply Quote from Cor Berkelaar: How on earth do I get the black ribbon cable back into its connector???
Luckily, it's a relatively easy thing to fix." Replacing the earpiece speaker in your iPhone 3G or iPhone 3GS is one of the easier DIY repairs. Iphone Earbuds Not Working Went to prefs set output to internal Posted on Nov 6, 2011 5:10 PM Reply I have this question too by Lodoss,Solvedanswer Lodoss Level 1 (10 points) A: Tony, Make When I plug a headphone into jack it does not shut of speakers and sound does not go to headphone. https://www.cnet.com/news/no-iphone-audio-speaker-or-earpiece-not-working-a-simple-fix/ I mistakenly tried to pry up the wrong piece, but fortunately didn't do too much damage before I realized this.
gnosis2 - 01/06/2010 Reply Quote from cochranb: Hi yes you are correct, I discovered my problem was really that cable #2 had come loose. Iphone 3gs Ear Speaker Not Working If i connect to itunes on the pc i can see the device and i put into restore mode that was completed, anyway no way to get it booting.I repeated the I mistakenly tried to pry up the wrong piece, but fortunately didn't do too much damage before I realized this. HOW TO REPLACE THE HOME BUTTON - Duración: 10:04.
There's only 1 screw holding it in. https://discussions.apple.com/thread/3469729?start=15 Soon after I was afforded an upgrade and got a new iPhone 4 and was able to keep the 3GS. Headphones Not Working On Iphone 6 Acción en curso... Iphone 3gs Speaker Not Working Liam George - 05/01/2010 Reply While disassembling, the screw in the far right corner should be separated from the other screws.
Now carefully use the suction cup to 'walk/rock' the screen out with a left-to-right while pulling up motions. http://virtualthought.net/iphone-3/iphone-3gs-no-sound-at-all.html Good luck! On the iPhone, this can trip a sensor inside the jack, which tricks the phone into thinking headphones are plugged in. (This sensor automatically mutes the phone's earpiece.) So before you Wear safety glasses to protect your eyes from any glass shaken free during the repair. Iphone 3gs Speaker Repair
How can I remove the small switch from the old flex cable? Must Tech TV 573.946 visualizaciones 3:38 IPhone speaker fixed - Duración: 1:48. Additional resources: How to remove an iPhone 3G or 3G digitizer assembly iMore Mod and DIY forums Even more DIY repairs and mods Like us! http://virtualthought.net/iphone-3/iphone-3g-wifi-not-working.html Hope this helps someone.
A butter knife worked extremely well, however ... Iphone 3g Speaker Replacement After this damage the proximity sensor won't work anymore. jake2 - 06/09/2010 Reply Please note that iFixit supplied screwdriver is way too big for these tiny screws, you'll need a smaller one like the ones used to repair wrist watches!
I have set of new screws here an I need to sort them - I can't find any specifications on the two screws mentioned here. All very odd. I would recommend sliding in the SIM card tray *before* putting any screws back, just to make sure. Iphone Stuck In Headphones Mode Please type your message and try again. Tony Brave Level 3 (639 points) Audio Q: Headphone jack not working Lion 10.7.2.
Cargando... Be careful not to apply too much heat to the switch, and don't burn your fingers! viper501 - 11/13/2009 Reply Splendid job. check over here Leon Stacey 34.014 visualizaciones 6:54 iphone 3g earpiece removal/replacement - Duración: 3:25.
I had to wiggle in the speaker end (where the 3 cables are) several times to get the display to seat perfectly, but all is well. I'm pretty sure that there is the problem, and it will never work, no matter what you do. If your phone was assembled the same as my 16GB 3G, the cable labeled 4 in step 3 is glued to the back of your LCD not simply connected to the Process took 2 hours, mostly disassembly and fitting the new part.
It should now easily lift from the assembly to reveal your earpiece speaker. I managed to get my #5 connector trapped under it. Was that the reason? As good as I'll get arsoofiwork - 01/30/2014 My Problem My headphone jack had been loose for months.
© Copyright 2017 virtualthought.net. All rights reserved.